Цитата:
Сообщение от Sedy
Так а где и чем мне понизить?
|
Можно не понижать, а использовать Test Point и SETool.
При использовании Test Point, версия не играет роли.
Процедура раскодировки msm7227, qsd8250 для SETool с применением Test Point
Цитата:
|
Сообщение от the_laser
FIRMWARE VERSION DOES NOT MATTER, WHEN USING TESTPOINT METHOD
1.
prepare for testpoint operation.
check testpoints location for your phone model in dist\docs\s1_qualcomm_uart_cables or use GPG cable set
open testpoints for access
if you do not have GPG cable set, get some needle with wire, connect it to phone gnd ( battery minus ) or to usb cable shield, etc.
2.
select proper phone model.
select COM as interface.
on settings check signed mode, use alternative security bypass, do full unlock instead usercode reset, use testpoint (gnd type)
fill login/password and check if account valid.
press unlock
when prompted, execute steps in EXACT order:
1.remove cable from phone,
2.remove battery from phone,
3.attach testpoint ( turn on switch on cable set )
4.insert cable to phone, HOLDING TESTPOINT ( cable set switch in "on" position )
5.press "ready"
6.when prompted detach testpoint
7.press "ready"
8.install drivers from dist\drivers\USBFlash_driver\ ( if asked )
|
